9502 Thermal Room

Thermal room ZappBug is a chamber that uses a heating system to exterminate bedbugs. ZappBug Room™ has a huge capacity to treat many objects infested with bedbugs. The treatment may be started immediately and it is not necessary to treat before the infested objects with solution, powders or other hazardous pesticides. ZappBug Room™ provides a rate of extermination of 100% of all bedbugs at all stages of life, including eggs, the larvae and adults. An non-toxic and natural alternative to get rid of bedbugs.

Instructions for Use:

1. Insert the infested items into the room bag, making sure it is not overloaded and the items do not touch the walls of the bag, allowing proper air circulation.
2. Place the temperature sensor deep inside the items. This is essential to ensure that the desired temperature is reached inside the items, not just on the outside. After that, zip the bag closed.
3. Connect the thermal room to the power supply and set the timer. The heating duration varies between 3 and 8 hours, depending on the load of the heater and the ambient temperature. (For example: If the heater is used in a warm environment with a light load, the duration may be shorter. For a heavier load or if the environment is cooler, the time required to reach the desired temperature will be longer).
4. Once the temperature reaches 49°C, the timer should be set for a minimum of 60 minutes or more, if necessary. Always monitor the internal temperature with the included wireless thermometer. As the temperature in the thermal room rises, the items inside will begin to heat up, and bed bugs will be eliminated.
5. After completing the heating cycle, allow the items to cool completely before removing them from the thermal bag. (WARNING: After heat treatment, the items may be hot, and handling them should be avoided until they have fully cooled to prevent burns, especially in the case of metal objects like zippers).

Factors that may influence efficiency: If the temperature in the room where the heater is placed is low, the time required for heating may be longer. To ensure optimal efficiency, follow all the manufacturer's instructions and recommended safety measures.

The temperature level which ZappBug Room™ can reach is between 50° C and 70° C and is safe for the majority of your goods:

- sofa;
- mattress;
- table;
- paper;
- clothes;
- chairs;
- shoes;
- books;
- bed sheets;
- electronics.

This room will help with the treatment of several items at once, thus reducing the extermination time of bedbugs. Shall be transported very easily and can be stored in the included baggage.

ZappBug Room™ is easily transported and can be assembled easily by one person in less than 10 minutes. It can be used in commercial or residential centers using a 220~240V source/1500W. It included a wireless digital thermometer to make sure that the internal temperature reaches over 50° C.

Dimensions: L: 2,8 m x W: 1,46 m x H: 2 m.

ZappBug uses thermal insulation materials that reflect heat and increases efficiency, reducing the treatment time.

Bedbugs eggs are almost transparent and almost impossible to identify. The best way to get rid of them is to use this heat treatment for all the objects that were in the nearness of the bedbugs infestation. The bedbug can survive up to 18 months without feeding.

Observation:

Bedbugs suffer in case of thermal shock and can not escape through the pipe while the heating is on. For that you must always make sure that the device is switched on before putting objects in it.

Use only indoors at a temperature not below 18° C, if the ambience of the chamber is below 18° C the thermal room ZappBug Room™ will not be able to reach the required temperature which kills the bugs.

As soon as the temperature reached 49° C, the timer is set to a minimum of 60 minutes or more if necessary (recommended 6 hours). Always monitor the indoor temperature with the wireless thermometer included.

Do not place it directly on cold surfaces such as cement or tiles.